#PIC16F628A SERIAL PROGRAMMER DRIVER#
#PIC16F628A SERIAL PROGRAMMER CODE#
#PIC16F628A SERIAL PROGRAMMER PC#

Digital Clock with AT89C2051 Circuit OperationShort SW2 presses cycle through displaying the current time in HH:MM and MM:SS form.

Adjustable voltage power supply Among the most important electronic devices in the electronics laboratory is the voltage source.

So in case it is not set correctly the jumper according to capsule type of uC, risk of destruction the device is very high. This programmer changes the power supply from J2 according to the selected device (8 - 18 Pins) or (28 - 40 Pins), from jumpers. An 16 pins uC will not work with this board, with some adapters might work.

For an uC with 8, 14, 18 pins you have to move the jumper on pins no.2 and no.3. Note: The connector J3 has three pins, no.1 has a square pad if you want to program a uC with 28 or 40 pins you will need to put a jumper on The programmer doesn’t need external power supply and takes all necessary signals and power from RS232 port This programmer does not support all PICs uC. It proved to be faster under WinXP, especially when programming larger PICs (dsPIC and PIC18F).PIC-PG2C is low cost serial port programmer for 8, 18, 28 and 40 pin PIC microcontrollers.

#PIC16F628A SERIAL PROGRAMMER DRIVER#

Besides SMPORT, the PortTalk driver can be used.All languages are now contained in the installer (no need to download anything separately) Thanks to various collaborators, a French, Greek, Portugese, Spanish, and Turkish translation of WinPic’s user interface is available.The only(?) interfaces which WinPic doesn’t support are Microchip’s “PicStart plus” (far too expensive) and “PicKit2”. WinPic now also supports JDM PIC-programmer 2, Velleman K8048, the Hoodmicro, the Willem interface, El Cheapo, and many others.Extra window with “Reload & program” function (always in front of others).Invocation with command line arguments is possible, so you can run WinPic from a shell.

#PIC16F628A SERIAL PROGRAMMER CODE#

Built-in “hex editor” for quick patches in code or data EEPROM memory.Bulk erase (“erase all”) or individual programming of all bytes present in from HEX-file.Code and data memory may be programmed separately.Code memory size now up to 8192 words, data EEPROM memory up to 256 byte.

#PIC16F628A SERIAL PROGRAMMER PC#

requires a PC with WIN95, Win98, Win XP (Win NT 4.0 and Win2000 not tested).

possibility to verify the PIC at different voltages (almost “production grade”).

exotic interfaces can be supported through a specialized hardware-interface DLL (plugin).

many other interfaces can be driven with a simple interface definition file (see manual).

parallel interface: compatible with SM6LKM’s “PIP84”-interface.

Most interfaces for the COM-port should work without a special port-access driver, and may even work with USBRS-232 adapters now !

serial interface: compatible to the “COM84”, “JDM”, and user-defined.

This is a simple program for Win95/98/XP to program the PIC firmware from a HEX-file (the type generated by Microchip’s MPLAB TM) into a PIC microcontroller. Connect programmer to PC through serial port cable or USB cable and power up, then the. QL-2006 programmer is the high-speed programmer designed specially for development and production programming of PIC single chip microcomputer (SCM) by QLS Electronic Technology Co., Ltd. QL2006 USB & RS232 PIC Programmer for Microchip MCU: Introduction.

Pic16f628a Serial Programmer